Conair Indoor Furnishings BE84 User Manual

9. To disconnect, be sure mirror is in the off position,  
then remove plug from outlet.  
10. Do not leave appliance unattended when it is  
plugged in.  
11. Be sure mirror is not in a position where it can  
reflect sunlight; reflected sunlight can cause fire.  
12. Do not use on a soft surface such as a bed, where  
openings may be blocked.  
13. Touch knob on mirror base until light shuts off.  
Allow unit to cool and unplug cord before replacing  
light bulbs.  
14. Do not place or store appliance where it can fall  
or be pulled into a tub or sink.  
CAUTION: BE SURE DIRECT SUNLIGHT DOES  
NOT STRIKE MIRROR WHEN LEFT UNATTENDED;  
REFLECTED SUNLIGHT CAN CAUSE FIRE.  
1. Your lighted makeup mirror will rotate 350° so that  
you can use either the normal, flat mirror or the 8x  
magnifying mirror located on the opposite side.  
2. Plug into any standard 120  
volt wall outlet. The mirror light  
is activated by touch. Touch the  
base to turn light on or off.  
3. After use, always touch the  
knob on the base to turn the  
mirror to the OFF position  
and unplug.  
3. Carefully lift off the removable housing from the  
half that is affixed to the stand.  
IMPORTANT SAFETY  
INSTRUCTIONS  
4. A cable tie is used to  
protect the fluorescent tube  
lamp during transportation. To  
replace the fluorescent tube  
lamp, you must first cut the  
cable tie. While holding the  
WHEN USING ELECTRICAL APPLIANCES, BASIC  
SAFETY PRECAUTIONS SHOULD ALWAYS BE TAKEN,  
INCLUDING THE FOLLOWING:  
READ ALL INSTRUCTIONS  
BEFORE USING APPLIANCE.  
KEEP AWAY FROM WATER  
DANGER TO REDUCE THE RISK  
OF ELECTRIC SHOCK: ALWAYS UNPLUG THIS  
APPLIANCE FROM THE ELECTRICAL OUTLET  
BEFORE CLEANING.  
socket, pull the fluorescent  
Fig. 2  
tube lamp out of the socket  
with care to avoid breakage.  
(see Fig. 2.) Align the metal  
pins on the fluorescent tube  
lamp with the holes in the  
socket and push gently to  
secure. (see Fig. 3.) After  
the fluorescent tube lamp is  
15. If an appliance falls into water, unplug it  
immediately. Do not reach into the water.  
4. The beauty and design of this mirror complement  
any decor. Therefore, you may wish to leave the  
mirror displayed. However, if you choose to store  
the mirror, see section about storage for detailed  
information.  
16. To protect against electrical hazards, do not use  
while bathing or in the shower.  
17. Never use while sleeping.  
replaced, there is no need to  
Fig. 3  
replace the cable tie.  
WARNINGTO REDUCE THE RISK  
OF BURNS, ELECTROCUTION, FIRE, OR INjURY TO  
PERSONS:  
1. Unplug from outlet before putting on or taking  
off parts.  
2. This mirror should not be used by or near children  
or individuals with certain disabilities.  
3. Use this mirror only for its intended use as  
described in these instructions. Do not use  
attachments not recommended by the manufacturer.  
4. Never operate this mirror if it has a damaged cord  
or plug, if it is not working properly, if it has been  
dropped or damaged, or dropped into water. Return  
the mirror to a service center for examination and  
repair.  
5. Keep the cord away from heated surfaces.  
6. Never drop or insert an object into any opening.  
7. Do not use outdoors.  
5. Carefully replace the removable half after locating  
and aligning the screw holes to the fixed half.  
18. Do not use a bulb greater than 13 watts.  
Special Feature  
Use on any 120 volt 60 hertz AC electric outlet  
(ordinary house current). Do not use it on any other  
electrical outlet.  
This lighted makeup mirror uses a fluorescent  
bulb. The bulb lasts up to 10,000 hours and does  
not require replacement. In the unlikely event  
that the bulb does need replacement, follow the  
instructions below.  
6. Insert screws into screw holes and tighten.  
FOR HOUSEHOLD USE ONLY  
SAVE THESE  
INSTRUCTIONS  
REPLACING FLUORESCENT TUBE LAMP  
CAUTION: Turn off power and unplug mirror. Allow  
to cool at least three minutes before replacing  
fluorescent tube lamp. Replace tube lamp only  
with tube lamp of same wattage rating. Remove  
tube lamp with care to avoid breakage.  
OPERATING  
INSTRUCTIONS  
RePlACINg FlUOResCeNT TUBe lAmP  
To reduce the risk of electric shock, this mirror has a  
polarized plug (one blade is wider than the other). This  
plug will fit in a polarized outlet only one way. If the plug  
does not fit fully in the outlet, reverse the plug. If it still  
does not fit contact a qualified electrician to install the  
proper outlet. Do not change the plug in any way.  
1. This mirror uses a 13W  
maximum 120V type plug-in  
fluorescent tube lamp.  
8. Do not operate where aerosol (spray) products are  
being used or where oxygen is being administered.  
2. Remove screws from left and  
right sides of mirror. (see Fig. 1.)  
Fig. 1  
 

Craftsman Lawn Mower 917377544 User Manual
Cub Cadet Lawn Mower 190 190 100 User Manual
Cub Cadet Lawn Mower 1325 User Manual
Cub Cadet Lawn Mower 1572 User Manual
Cuisinart Blender DLC 2007N User Manual
DigiTech Musical Toy Instrument Element User Manual
Electro Voice Microphone PL24 User Manual
Electro Voice Portable Speaker Phoenix User Manual
Frigidaire Cooktop 318200603 User Manual
GE DVD Player DGE100N User Manual