ETA Systems Power Supply PD9L User Manual

1450 Lakeside Dr., Waukegan, IL 60085 USA  
330-677-4424 • 800-321-6699 • Fax: 330-667-4471  
OWNER’S MANUAL  
OPERATION INSTRUCTIONS  
January 2006  
ETA’s line of Conditioned  
Power Distribution units are designed to extensive damage or destruction of  
cause premature failure, or result in  
refer trouble-shooting to a qualified  
electronic technician or contact ETA  
Customer Service for assistance.  
prevent electrical damage to sensitive  
electronic equipment from high ampli-  
tude/short duration spikes, random  
surges, and EMI/RFI noise, which is  
inherent in utility power lines. Power  
line sources which are not precondi-  
tioned or filtered can affect reliable  
operation of sensitive audio, computer, indicates the power conditioning cir-  
and other electronic equipment, and  
may cause premature failure, expensive outlets are powered. Maximum total  
electronic equipment.  
ETA Conditioned Power Dis-  
tribution units feature a master power  
switch, conveniently located on the  
front control panel, that switches the  
rear panel AC outlets ON and OFF. An  
LED next to the master power switch  
EASY INSTALLATION  
The PD9L is easily mounted  
into a standard 19-inch rack or placed  
into a free-standing position. With the  
cuitry is working and the rear panel AC master power switch in the OFF posi-  
tion, plug the line cord into a conven-  
ient AC receptacle. Place the unit’s  
power switch into the ON position and  
check that the front panel LED is lit.  
repairs, or unanticipated replacement  
from non-repairable damage.  
wattage input is 1800 watts and the 8  
power output receptacles, located on  
As inherent problems in utility back panel and one on front panel, are  
AC power lines increase for various  
reasons, and the need for noise-free,  
conditioned power increases, ETA is  
protected with a 15-amp (total unit) re- The lit LED indicates conditioned and  
settable circuit breaker. filtered AC power is connected. Then,  
Note: The front panel LED is with their master power switches in the  
there with the units to protect your valu- normally lit when the power switch is in OFF position, plug the equipment to be  
able electronic equipment. With present the ON position. If the power switch is protected into the PD's rear panel AC  
demands on the power utilities, voltage ON and the LED is not lit, power may  
receptacles. Turn on the power switches  
spikes, power surges, electrical noise,  
and power failures are commonplace.  
This "garbage" in the power delivered  
still be present on the output AC recep- of the equipment plugged into the  
tacles, but the power conditioning cir-  
cuitry is not working. Do not continue  
PD9L..  
NOTE: The PD9L is UL recognized  
can reduce the fidelity of audio systems, use of the power conditioning unit and and has a one-year limited warranty.  
All designs and specifications are subject to change without notice. Copyright © 2004 ETA Systems.  
 

Eclipse Fujitsu Ten Car Stereo System CD2000 User Manual
Edelbrock Automobile Parts 1604 User Manual
Electro Voice Microphone DL42 User Manual
Fagor America Convection Oven 6HA 200 TDX User Manual
Frigidaire Air Conditioner FRA086AT7 User Manual
GE Cooktop 169214 User Manual
Generac Power Systems Portable Generator SG010 User Manual
Genicom Computer Hardware P45 User Manual
GE Washer Dryer S2100 User Manual
GE Water System GNSH45E User Manual