Fellowes Paper Shredder P500 2W User Manual

PAPER SHREDDER  
Personal Series  
DESTRUCTEUR DE DOCUMENTS  
Série usage personnel  
DESTRUCTORA DE DOCUMENTOS  
Serie de uso personal  
USE AND CARE MANUAL  
MANUEL D’EMPLOI ET D’ENTRETIEN  
MODO DE EMPLEO Y DE CUIDADO  
PLEASE READ AND SAVE THIS MANUAL WITH YOUR ORIGINAL RECEIPT  
Customer Service: 1-800-955-0959  
VEUILLEZ LIRE CE MANUEL ET LE CONSERVER AVEC LE TALON D’ACHAT  
Service clientèle (Canada) : 1-800-665-4339  
POR FAVOR, LEA Y GUARDE ESTE MANUAL CON EL RECIBO ORIGINAL  
Dpto. de Atención al Cliente: 1-800-955-0959  
 
IMPORTANT SAFEGUARDS  
PARTS OF THE SHREDDER  
G
A
• NEVER insert hands or fingers into paper entry as serious personal  
injury may result.  
C
D
• THIS MACHINE IS NOT A TOY. Keep children and pets away from  
shredder AT ALL TIMES as serious injury may result. Always  
unplug shredder when not in use.  
• Keep loose objects (jewelry, ties, long hair) away from shredder.  
These items and others like them may cause serious injury if they  
accidentally fall into the paper entry.  
E
B
F
• Do not exceed recommended sheet capacity.  
• Do not shred plastic (except credit cards), continuous forms, adhe-  
sive labels, transparencies, newsprint, or cardboard.  
• This personal shredder is intended for paper only. Do not attempt  
to shred paper clips or other hard materials (except staples).  
• Do not place shredder near or over a heat source or water.  
• Always turn off and unplug unit before moving or cleaning and  
when not in use.  
• Do not insert aerosol cleaners or lubricants into or around the  
shredder. Some agents may combust, causing serious injury.  
• Do not use this product if it or the cord has been damaged in any  
way.  
A. Paper entry  
B. Basket  
C. A u t o-start sensor  
D. Power switch  
E. Shredder head  
F. Viewer  
G. Manual forward button  
ASSEMBLY  
To assemble shredder head onto basket  
1. Position shredder head over basket as shown in Figure 1.  
2. Lower shredder head onto basket aligning the rim on the under-  
side of the shredder head with the edge of the baske t .  
• Do not open the cover for any reason. Doing so can expose you to  
dangerous voltages and will void your warranty.  
Power Cord Care  
• Place power cord in an easily accessible position, because it is the  
main disconnect switch.  
• Do not place machine where adults, children or animals may walk  
on the cord.  
• Do not rest anything on the power cord.  
• If an extension cord is used, be sure that all products plugged  
into the extension cord do not exceed the extension cord ampere  
rating.  
Figure 1  
2
 
6. Move power switch to OFF (O) position when shredding is com-  
plete.  
7. Unplug power cord from outlet when shredder is not in use.  
8. Look through viewer to see if basket is full. If full, lift off shredder  
head and empty basket contents. Replace shredder head into posi-  
tion on baske t .  
OPERATION  
This product features an auto-start sensor. This  
sensor will turn on the cutting blades whenever  
anything is inserted into the paper entry (while the power switch is in  
the AUTO (I) position). For the safety of pets and children, we recom-  
mend always moving the power switch to OFF (O) and unplugging  
whenever the shredder is unattended or not in use.  
1. Assemble shredder head to basket (see ASSEMBLY”).  
2. Remove any paper clips or other foreign objects (except staples)  
from paper. If folding paper to fit paper entry, adjust sheet capaci-  
ty appropriately.  
Cool-Down Cycle  
This shredder is protected with a special safety feature which prevents  
the motor from overheating with extensive use. Whe n shredd ing  
i s atte mpt ed beyo nd the ma chine 's ma ximu m ru n -  
ni ng time , the shredder wil l automa ti cally shut off  
i ts motor unti l it ha s cool ed to an acceptable ope r -  
ating le vel . This is normal and the shredder will return to opera-  
tion after the “cool-down” period. See “Product Usage Guide” (page  
1) for maximum running time and related cooling or “off” time.  
Do not attempt to shred paper clips or other  
hard materials (except staples) with this  
machine. Extensive use of paper clips or other hard materials will  
result in damage to the cutting system and will void the manufactur-  
er's warranty.  
3. Be sure power switch is in the OFF (O) position. Plug shredder  
into the proper power supply outlet.  
4. Move power switch to AUTO (I) position. As soon as the unit is  
turned on, it is in autostart mode, ready to be fed paper through  
the paper entry.  
Clearing a Jam  
If the shredder sheet capacity is exceeded or paper is not put in  
straight, a jam may result. See “Product Usage Guide” (page 1) for  
maximum sheet capacity for your shredder. In the case of a jam, the  
machine will “bog down” and fail to shred the paper.  
To clear a jam:  
1. Move the power switch to the REVERSE (R) position. (If waste  
basket is full, empty it before clearing jam.) The shredder will  
reverse the paper to clear the jam.  
NEVER insert hands or fingers into paper entry as  
serious personal injury may result.  
Do not exceed recommended sheet capacity (see  
“ Product Usage Guide” on page 1).  
2. If the shredder jams in reverse, move the power switch to AUTO  
5. Slide paper straight into paper entry until the shredder auto-  
(I), depress the manual forward button  
and allow to run  
matically begins shredding.  
for about five seconds. If jam does not clear, move power switch  
to REVERSE (R) again and allow to run for about five seconds.  
Repeat this procedure until the jam is cleared. If necessary, use  
care to grasp the paper and pull out to clear the jam.  
The shredder automatically stops when shredding is complete.  
Continue shredding as desired to a MAXIMUM shredding time  
of 5-7 minutes. At this time, the machine MUST be allowed to  
“cool down” for a MINIMUM of 15 minutes. (See “Cool-  
Down Cycle” section for more information.)  
3. Once the jam is cleared, move the power switch to AUTO (I) for  
continued shredding or OFF (O) if shredding is complete.  
If the shredder jams or shuts off before the maximum shredding  
time, see “Clearing a Jam” section for further instructions.  
3
 
TROUBLESHOOTING  
LIMITED WARRANTY  
Fellowes Manufacturing Company (the “Company”) warrants the cut-  
ting cylinders of the machine to be free from defects in material and  
workmanship for 3 years from the date of purchase by the original  
consumer. Fellowes warrants all other parts of the machine to be free  
of defects in material and workmanship for 1 year from the date of  
purchase by the original consumer. If any part is found to be defective  
during the warrant period, your sole and exclusive remedy will be  
repair or replacement, at Fellowes’ option and expense, of the defec-  
tive part.  
Shredder will not  
operate.  
a. Shredder is not plugged in.  
b. Power switch is in the OFF (O)  
position. Move switch to AUTO (I)  
position.  
c. Shredder is jammed. See “Clearing  
a Jam” section.  
d. Shredder has exceeded the maxi-  
mum run time and requires a “cool-  
down” time. See “Product Usage  
Guide” (page 1).  
This warranty does not apply in cases of abuse, mishandling or unau-  
thorized repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF  
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS  
HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY  
PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for  
any consequential or incidental damages attributable to this product.  
This warranty gives you specific legal rights. You may have other  
legal rights that vary from state to state.  
Shredder suddenly  
stops while  
shredding.  
a. Shredder has exceeded the  
maximum run time and requires a  
“cool-down” time. See “Product  
Usage Guide” (page 1).  
b. Shredder is jammed. See “Clearing  
a Jam” in the OPERATION section.  
For more detail or to obtain service under this warranty, please con-  
tact Fellowes Customer Service at 1-800-955-0959, Monday through  
Friday, 8 AM - 5 PM (Central Standard Time).  
Shredder operates  
only in REVERSE.  
A small piece of paper may be blocking  
the auto-start sensor of this shredder.  
Move the power switch to AUTO (I) and  
depress the manual forward button  
for 5 seconds to clear paper blockage.  
For specific instructions on obtaining service under this warranty on  
machines purchased outside the USA, contact the appropriate location  
listed in the Contact for Service section of this instruction manual.  
Warrantor: Fellowes, Inc.  
Shredder runs  
continuously when  
in AUTO.  
a. Look through viewer to see if baske t  
is full. If full, lift shredder head and  
empty basket contents. Re p l a c e  
shredder head into position on  
basket.  
b. A small piece of paper may be  
blocking the auto-start sensor of  
shredder. Move power switch to  
AUTO (I) and depress the manual  
forward button  
for 5 seconds  
to clear paper blocka g e .  
Fellowes conducts extensive testing to ensure that these shredders are capable of meeting all of the specifications listed in the  
Usage Guide. However, the actual sheet capacity is dependent on a number of factors including the type and weight of paper,  
the humidity, the voltage level of the power source, the temperature of the motor, and the care with which the operator feeds the  
paper. Safety agency testing is conducted to ensure that the shredder will operate to specifications even if the available voltage is  
10% below or 6% above the rated voltage.  
Model  
Voltage  
220-240VAC  
120V  
220-240VAC  
120V  
Hertz  
50HZ  
60Hz  
50HZ  
60Hz  
Cut Size  
6.3mm  
6.3mm  
6.3mm  
6.3mm  
Number of Sheets  
Paper Size & Weight  
8.5x11 20 Lb.  
8.5x11 20 Lb.  
8.5x11 20 Lb.  
8.5x11 20 Lb.  
P500-2  
P500-2  
P700-2  
P700-2  
7
7
10  
10  
4
 
© 2002 Fellowes. Printed in China. Form No. 30105B  
 

Euro Pro Vacuum Cleaner UV209B User Manual
Extron electronic Network Hardware IPL T PCS4 User Manual
FOCUS Enhancements TV Receiver SXGA User Manual
FoneGEAR Battery Charger 06265 User Manual
FoodSaver Food Saver II Turbo User Manual
Fostex DVR D 25 User Manual
Fujitsu Telephone F9600 F9600c User Manual
GE Air Cleaner 169018 User Manual
GE Monogram Refrigerator ZIC360NM User Manual
Gianni Industries Door LZ NH2300N User Manual